How to avoid the distortion that occurs in the transmission line?

distortion of line

What are the types of line distortions? The distortions occurring in the transmission line are called waveform distortion or line distortion. Waveform distortion is of two types i.e. frequency distortion and phase or delay distortion. How frequency distortion occurs in a power transmission line? When a signal having many frequency components are transmitted along the line,… Read More: How to avoid the distortion that occurs in the transmission… »

Transmission Line Theory & Vocabulary

surge impedance loading

The parameters of a transmission line are Resistance (R), Inductance (L), Capacitance (C) and Conductance (G). Resistance (R) is defined as the loop resistance per unit length of the wire. Its unit is ohm/Km.  Inductance (L) is defined as the loop inductance per unit length of the wire. Its unit is Henry/Km. Capacitance (C) is defined as the loop capacitance per… Read More: Transmission Line Theory & Vocabulary »

Cable Management Best Practices

cable baskets cable management system

Cable Management is a key component of Data Center and Network Management. It refers to an important step during the installation of building services (ie electrical services) and the subsequent installation of equipment providing means to efficiently secure electrical, data, and other cables including the power distribution system. Properly arranged cables increase problem resolution time dramatically.… Read More: Cable Management Best Practices »

Typical Design Philosophy of Cable Trays for Power Plant

cable tray design criteria

Cable tray system shall be used for laying of MV and LV power, control, instrumentation and special cables in the Power Plant.  Cable trays shall be supported on cantilever brackets at specified interval. The trays shall be strong enough to keep the deflection of the fully loaded tray within permissible limits. In general, cable trays run in… Read More: Typical Design Philosophy of Cable Trays for Power Plant »

Electrical Installation Work Procedure for Conduits Sleeves & Boxes

This method statement details general electrical installation procedure that is useful for construction of electrical work for houses or any other building projects. Electrical engineer can understand basic requirements and how to arrange the sequence of electrical work. Project Manager shall be responsible for the implementation of this procedure for electrical work and co-ordinate with the… Read More: Electrical Installation Work Procedure for Conduits Sleeves & Boxes »

LV Low Voltage Switchgear Components

LV low voltage switchgear diagram

Electrical switchgear are very important part of any electrical distribution system. Switch gears are used for many purposes like protection, isolation from live parts and switching operation. A switchgear is the combination of electrical disconnect switches, fuses or circuit breakers used to control, protect and isolate electrical equipment. Switchgear is used both to de-energize equipment… Read More: LV Low Voltage Switchgear Components »