Below method statement covers installation and connection of all interior and exterior lighting, lighting control devices and wiring devices according to the approved shop drawings, project specifications and other related codes. One of the purpose of this method statement is to coordinate the exact location and position of all lighting fixtures, switches, outlet boxes and… Read More »
Below document covers the uninterruptible power supply UPS system installation, testing and commissioning method statement. Before starting the UPS installation work, user manual must be thoroughly read and understood. Applicable safety instructions and warnings must be discussed and appropriate measures must be taken. It is strictly recommended that trained service engineer from manufacturer or authorised… Read More »
Before start of the installation works exact locations of luminaries will be checked and it should be as per approved RCP (reflected ceiling plan) drawing. Installation shall be carried out by skilled and suitably experienced electricians under supervision of highly competent site supervisors and engineers to ensure the correctness and best quality of installation. Light… Read More »
Below is a precise electrical installation method statement that covers installation of main distribution board and MCC panel board in compliance with the approved design, drawings, manufacturer instructions and material submittals. The electrical or MEP project manager is overall responsible for the implementation of this procedure and any relevant documents/standards. Site Engineer will be responsible… Read More »
Objective of this method statement is to explain the procedure for the Installation of Cathodic Protection System for a construction project in compliance with local and international regulations. This method statement identifies the work related general steps and necessary arrangements, scope of this document includes preparation of equipment, manpower, installation, rebar continuity test for critical… Read More »
The electrical method statement below provides the brief steps to be carried out during the AC High voltage testing. Method statement applies to the testing of 11 KV switchgear. Testing and commissioning engineer / responsible person shall obtain all necessary clearances and safety document from concern authorities. He shall ensure the work is done as… Read More »